ETH-RLY16 Ethernet Relay

Devantech

Overview

The ETH-RLY16 provides eight volt free contact relay outputs with a current rating of up to 16Amp each. The module is power from a 12vdc supply which can be regulated or unregulated. The DC input jack is 2.1mm with positive core polarity, DC supplies are required to supply at least 500mA at 12vdc. The relays are SPCO (Single Pole Change Over) types. The normally open, normally closed and common pins are all available on the screw terminals.

Operating Temperature

-40°C to +70°C

LED indication

The ETH-RLY16 provides a red LED mounted immediately next to each relay to indicate whether it is in a powered state (LED on), there is also two LED's mounted in the Ethernet connector which will flash with Ethernet traffic. Finally there is a red power LED alongside the screw terminals.

Relay power rating

If the contact load voltage and current of the relay are in the region enclosed by the solid and dotted lines in the figure below, the relay can perform stable switching operation. If the relay is used at a voltage or current exceeding this region, the life of the contacts may be significantly shortened.

load type	Typical applications	Rating	Max DC load capacity
AC1	Non inductive or slightly inductive loads	16A @ 250V AC
AC15	Control of electromagnetic load (>72VA)	3A @ 120V AC 1.5A @ 240V AC
AC3	Control of motor	750W
DC1	Non inductive or slightly inductive loads	16A @ 24V DC
DC13	Control of electromagnetic loads	0.22A @ 120V DC 0.1A @ 250V DC

Download

A full datasheet for the relays used on the ETH-RLY16 is here.

Accessories

PP-EURO-15W-12V Mains adapter with Euro plug

Manufacturer's data

Technical Specification - link to the manufacturer

Product information for: ETH-RLY16 - Ethernet Relais Modul

Publishing date (date of last technical specification): 2010-11-10
Shipping weight: 240 g
Manufacturer: Devantech Brand: ROBOT ELECTRONICS
Article number: ETH-RLY16