EMG30 gear-motor with encoder

Devantech

The EMG30 (encoder, motor, gearbox 30:1) is a 12v motor fully equipped with encoders and a 30:1 reduction gearbox. It is ideal for small or medium robotic applications, providing cost effective drive and feedback for the user. It also includes a standard noise suppression capacitor across the motor windings.

Measurements

Connector

The EMG30 is supplied with a 6 way JST connector at the end of approx 90mm of cable as standard.
The connections are:

Wire colour	Connection
Purple (1)	Hall Sensor B Vout
Blue (2)	Hall sensor A Vout
Green (3)	Hall sensor ground
Brown (4)	Hall sensor Vcc
Red (5)	+ Motor
Black (6)	- Motor

note that pull up resistors (we used 4k7) are required on the hall sensor outputs, and wires are the colours from the actual cable.

Specification

Rated voltage	12v
Rated torque	1.5 kg*cm (ca. 0,15 Nm)
Rated speed	170rpm
Rated current	530mA
No load speed	216
No load current	150mA
Stall Current	2.5A
Rated output	4.22W
Encoder counts per output shaft turn	360

Measured Shaft Speed when used off-load with MD23 and 12v supply

Minimum Speed	1.5rpm
Maximum Speed	200rpm

EMG30 Mounting Bracket

Providing easy mounting of the EMG30 to the robot, the bracket is made from a 2mm thick strong aluminum and finished in blue enamel.

Wheel 100

A 100mm diameter wheel with 5mm diameter hub for easy attachment to the EMG30, the wheel has a 26mm wide rubber tread

Manufacturer's data

Technical Specification - link to the manufacturer

Accessories

Product information for: EMG30 gear-motor with encoder

Publishing date (date of last technical specification): 2010-10-10
Weight: 140 g
Shipping weight: 240 g
Manufacturer: Devantech
Brand: ROBOT ELECTRONICS
Article number: DEV-EMG30
Manufacturer's part number: EMG30

The article EMG30 gear-motor with encoder is listed in the following categories:

Drives > Motors